关于在ArchLinux使用数位板

是高漫的1060Pro，心血来潮想要学一下板绘(我要画涩图！)，可是高漫并没有发布Linux的驱动，借助Google找到了个叫OpenTabletDriver的开源数位板驱动，刚好适配有高漫。

直接装了

其实官网有文档，不仅限于ArchLinux： https://opentabletdriver.net/Wiki/Install/Linux

yay opentabletdriver

装完还要稍微配置一下才能用

Welcome to OpenTabletDriver!
In order to start using this driver, there are certain things that have to be configured manually.

Replug your tablet if it is connected. This will re-trigger the udev rules accordingly.

The daemon can be started with:
  $ otd
You can fork it to the background and use output redirection to a log file if desired.
A systemd user service is also provided and can be used instead, assuming you have a correct systemd user graphical-session.target set up:
  $ systemctl --user enable --now opentabletdriver.service

You will have to manually unload built-in kernel modules (or reboot) in order for this driver to work properly.
To unload the module immediately, run:
  # rmmod <module>
Where <module> is 'wacom' if you own a wacom tablet, and 'hid_uclogic' otherwise.

As of version 0.6.2.0, having the package installed will block any modules related to drawing tablets
In the case that you still have issues after following these instructions, the FAQ at https://opentabletdriver.net/Wiki/FAQ/Linux may help.

精简版：

systemctl --user enable --now opentabletdriver.service